The 60 watt, all tube, 3 channel 12” combo using EL34 power tubes and two 12AT7 and two 12AX7 pre amp tubes has the ability to go from ultra clean to a warm bluesy tone to rock or all out aggressive metal.

The Divinity-12 has two separate EQ stages, one for clean and one for the two gain stages. A major design feature of the Divinity-12 was to allow the clean channel to remain clean even at extremely high volumes. This channel also includes a tube boost circuit that is switch able at the amp or the footswitch that acts like a light tube screamer.

There are two gain channels, edge 1 is designed to focus more on a mid tone or sharp sounding, defined distortion. Edge 2 is designed more with extra bottom end, a looser tone with extra sustain.

Of course quality features such as spring reverb, effects loop with volume switch, external speaker output, headphone output and 4 pin footswitch are included.

The Divinity 12 uses diode rectifiers, this keeps the defined tone alive. Definition is an important factor you may not want to loose if you like clarity and sharp tone or in other words, notes that can be fully understood and are as clear as a bell whether your in the clean channel or railin with full blown distortion in one of the others.

Electro Harmonix EL34 Power Tubes
Electro Harmonix 12AX7 and 12AT7 Preamp Tubes
Triple speaker outputs (4, 8 or 16 ohm selectable)
Effects Loop with Level Switch
Spring Reverb
Foot Switch

Power Handling:	60 Watts
Power Tubes:	Two EL34 Electro-Harmonics Russian tubes
Pre Amp Tubes:	Two 12AX7 and two 12AT7 Electro-Harmonics Russian tubes
Frequency Response:	20-20,000Hz
Cabinet Load	External speaker output (8ohm minimum)
Standard EQ Control:	Bass, Mid and Treble controls in gain channels
Effects:	Spring Reverb
Front Panel:	Gain Volume EQ controls EQ on or off switch
Options Included:	8 ohm Minstrel 12
Rear Panel:	Effects in and out with -3db switch / speaker outputs
Finish:	Stainless steel panel and chrome knobs
Warranty:	3 year
Size:
Weight:	55 lbs
MSRP:	$999